Posts

Land Farming Application Reduces TPH by 90% to 99%

Petrox microbes were added to excavated petroleum-contaminated soil to accelerate the degradation of DRO and ERO total petroleum hydrocarbons. Petrox was added by spraying the surface of the soil with a hydrated Petrox solution.  The microbes were mixed into the soil using a tractor-mounted disc tiller.  photo-2              photo-1

After approximately 60 days, soil samples were taken for testing.  The soils showed 90% to 99% petroleum removal.  The following chart shows the range of DRO and ERO concentrations before and after Petrox treatment.

land-farming-results

Surface Oil Spill Bioremediation

Petrox microbes provide quick response surface oil spill bioremediation.  Petrox can be applied to the oil surface with a backpack sprayer to initiate rapid bioremediation.  This approach protects surface water and vegetation with minimal surface traffic.

In the following example, an oil spill affected the vegetation and surface water at the edge of a lake. Contractors applied Petrox to the oil surface on vegetation and soil.  Periodic soil samples tracked the results.  After 90 days, the maximum and average concentrations decreased by more than 95% at a very low cost.

Surface Spill Results

Surface Spills to Deep Subsurface Success With Petrox Bioremediation

Petrox bioremediation is used to remove petroleum contamination from soil and water under many different conditions.  From surface spills to deep soil and ground water contamination, Petrox has successfully removed the contamination and environmental risk.  This summary of case studies demonstrates the applicability of Petrox bioremediation to the full range and life cycle of petroleum spills. Click here to view the document.

 

Bioremediation of Industrial Fill

Historical industrial sites often have deposits of fill material containing a wide range of organic contaminants.   Perched ground water  present in the base of the fill is usually impacted by the contaminants and may provide a mechanism for off-property migration of the contaminants.  The organic contaminants are wide spread throughout the fill without a well defined source area.  Cost-effective remediation is difficult with this combination of conditions.

Bioaugmentation with CL-Out or Petrox can remove the contaminants from the fill and perched water by destruction in place.  The organisms in CL-Out and Petrox can metabolize a wide-range of organic chemicals at concentrations from separate-phase layers to part per trillion levels.  Soil and ground water contaminants are addressed simultaneously though injection of the microbes without disturbing the  site operations.

The following table shows typical results from a single application of Petrox to contaminated soil and perched ground water on July 10, 2011.  The remediation progress was tracked by ground water monitoring because it was the easiest sampling method once wells were in place.Industrial Fill TreatmentThe results show that within 30 days the contaminant concentrations in perched water were reduced by 50%.  After 60 days there was slight rebound in come of the contaminants, showing that more soil treatment may be necessary if lower cleanup goals needed to be maintained.

 

 

California Site Closure with Petrox Bioremediation

Southern California Gasoline UST Release Site

After removal of USTs, piping and surrounding soils, ground water was treated with 110 gallons of Petrox® by direct injection in December 2009.  Post-treatment sampling shows that the bioaugmentation reduced the contaminant levels to below regulatory standards by the next semi-annual sampling round.

Sampling Date

TPHg Benzene Toluene Ethylbenzene

Total   Xylenes

MTBE
Pre-bioaugmentation

10/6/09

1,200 320 7.2 700

70

5
Post-bioaugmentation

4/26/10

<50 <0.5 <0.51 <1

<5

<0.5

All concentrations shown in µg/L.