Case Study: Petroleum Remediation in Central New Jersey
Petrox® bioaugmentation was implemented at a petroleum remediation site in Morris County, New Jersey to destroy residual petroleum compounds in ground water. The impacted ground water was in bedrock fractures under and down gradient of a former UST location. The UST was removed and an oxygen release compound was added to the ground water to stimulate bioremediation. However, residual contamination persisted and Petrox® bioremediation was implemented to remove the residual low concentration found at the site.
Geology and Hydrogeology
The bedrock surface was fairly close to the ground surface and the first ground water encountered upon drilling at the site was within the bedrock. Impacted ground water was contained within the fractures near the bedrock surface in a zone estimated to be 40 feet thick.
Low concentrations of benzene, xylene, ethylbenzene and toluene were present in ground water at and down gradient of the former UST cavity. The area of proposed treatment was 3,600 square feet.
Petrox was applied in two monthly applications of 8 units each. One unit of Petrox® is a 55-gallon slurry with a microbial concentration of 109 cfu/ml. ORC socks were installed in treatment wells to provide an oxygen source for the petroleum metabolism.
The monthly Petrox® injections were on May 29, 2009 and June 26, 2009. Post -treatment samples were taken on June 10, 2009 and May 4, 2010. The following table shows the contaminant concentration treads in the treatment area.
The treatment was successful in reducing the BTEX concentration at the site. However, the increase in concentrations after the first treatment showed that there were residual petroleum constituents in the source that was not reflected in the pre-treatment sampling. Petrox® microbes were detected in all of the bedrock sampling points as far as 30 feet down gradient of an injection point. Overall the treatment verified the effectiveness of Petrox® bioaugmentation in fractured bedrock.